Formed from engineered nylon and drive nails, Truss-Head Nylon Anchors are a fastening system that consists of two parts. It is installed by inserting the nylon shank into a pre-drilled hole and hammering the head of the nail until it meets the head of the anchor body. Driving the nail expands the split ends and allows the ribs to grip the wall of the hole.
GREAT FOR MASONRY ANCHORING: Light duty anchor for use in concrete, block, brick, or stone
PRE-DRILLING RECOMMENDED: For installation, drill a hole in the material that matches the diameter of the anchor
SAFE FOR TREATED LUMBER: Recommended for use with ACQ, CA, and CCA treated lumber
NOT RECOMMENDED FOR OVERHEAD FIXTURES: Anchor could pull out of material and fall when attempting to support an overhead load
CORROSION-RESISTANT: Material offers strong resistance to rust and corrosion
One (1) C-Pak per sellable unit
100 pieces per retail package
BrandHillman
Head TypeTruss
Inches-MetricInches
Interior-ExteriorInterior
Base MaterialNylon
Diameter1/4"
FinishWhite
Package TypeC-Pak
Primary ColorWhite
Product Length1"
Product Size1/4" x 1"
Pieces Per Retail Pack100
Secondary MaterialSteel